60 Hz Tone
Is that hum 50 or 60 Hz? Play the tone, compare the pitch. Press a tone button when your volume is low.
https://flxcode.com/60-hz-tone/
Set the volume low, then tap a tone.
Stopped
Most phone and laptop speakers can't play 60 Hz. You may hear only its harmonics.
Any other frequency: Tone Generator
No sound?
- iPhone: check the ring/silent switch and the media volume.
- Check the system volume and which output is selected (speakers, headphones, Bluetooth).
- Bluetooth headphones switch to call mode while a microphone is open: sound becomes mono and dull.
- A mono audio setting in accessibility makes left and right sound the same. A web page can't detect it.
- Another tab or app may be using the audio. Close it and press Play again.
No ads. No account. Nothing you type or record is uploaded. We count page events with a daily code. Check it.
Problem or idea? Email us
Hum check in four steps
- Turn the device volume down. The tone starts at 10 %.
- Pick your mains frequency at the top of the panel: 60 Hz or 50 Hz. Not sure? See the list below.
- Play the fundamental (60 or 50 Hz), then its 2nd harmonic (120 or 100 Hz). Raise the volume slowly. Stop if the speaker rattles or distorts.
- Listen to your hum and decide which of the two it sounds like. Most hum is the harmonic, the higher one.
On a good subwoofer or large headphones 60 Hz is a smooth deep note, closer to a felt rumble than a pitch. On a phone or laptop you will hear very little, or a faint buzz that is not the 60 Hz itself. That is why the pair matters: 120 Hz is easier to hear.
Which mains frequency do I have?
- 60 Hz: the US, Canada, Mexico, most of Central America, Brazil, South Korea, Taiwan, the Philippines, Saudi Arabia.
- 50 Hz: Europe, the UK, Russia, most of Africa, Australia, India, China, most of the Middle East.
- Japan uses both: 50 Hz in the east (Tokyo), 60 Hz in the west (Osaka).
The mains frequency is a property of the grid, so a hum from your wall socket follows your country, not your device.
Mains hum and its harmonics
Electricity in the wall alternates 50 or 60 times a second. Hum in audio gear is that frequency leaking in, plus whole-number multiples of it. Rectified power adds the strongest bit at twice the mains frequency, so the loudest part of a hum is often 100 or 120 Hz, not 50 or 60.
| Harmonic | 50 Hz mains | 60 Hz mains |
|---|---|---|
| 1st (fundamental) | 50 Hz | 60 Hz |
| 2nd | 100 Hz | 120 Hz |
| 3rd | 150 Hz | 180 Hz |
| 4th | 200 Hz | 240 Hz |
Each link opens the Tone Generator at that frequency, without playing.
Fundamental and harmonic
The fundamental is the mains frequency itself: 60 Hz or 50 Hz. A harmonic is a whole-number multiple of it: 120 Hz is the 2nd harmonic of 60 Hz, 180 Hz the 3rd. A hum is a stack of these, and the speaker plays the higher ones better. When you hear a hum and the 120 Hz tone sounds like it, you are hearing the harmonic, and the fundamental is probably there below it.
Speaker hum: 50 or 60 Hz, or 100 or 120 Hz?
Play the four tones and pick the one that matches your hum. Which one it is says where to look.
- Matches 50 or 60 Hz: a deep, steady drone. Often a transformer or power supply near the gear, or magnetic pickup from a mains cable.
- Matches 100 or 120 Hz: a buzzier, higher note. Usually a ground loop or a rectifier in a power adapter, the most common speaker hum.
- Matches neither: it is probably not mains. Try a rattle test, or a different cable.
A faint hum right next to a transformer or a charger is normal. If it comes from a wall socket or something smells hot, switch it off and call an electrician.
Why small speakers and earbuds barely play it
A speaker moves air. To make a low note at the same loudness it has to move much more air than for a high note, and a small cone cannot. Phone speakers play almost nothing under ~150 Hz. Earbuds do a bit better, depending on the fit in your ear. Some of what you hear from a laptop at 60 Hz is distortion: the speaker adds higher harmonics that it can play. So a tone you can hear is not proof that the speaker plays 60 Hz.
The same tone at the same volume setting is loud on one speaker and silent on another.
Troubleshooting a hum
Play the tone, listen to your hum, and compare the pitch. If it matches 100 or 120 Hz it is very likely electrical. Then try these, one at a time.
- Unplug the audio cable from the source. If the hum stays, the problem is in the amp or speaker. If it goes, it is in the source or cable.
- Plug everything into the same power strip. Two sockets on different circuits are a common cause of ground loop hum.
- Move power adapters, dimmers and fluorescent lights away from signal cables.
- Try a different cable, or a ground loop isolator, for unbalanced RCA and 3.5 mm connections.
- Hum that changes when you touch a metal part of the gear is usually a grounding problem.
- You can check what your microphone picks up with the mic test, which marks a hum at 50 or 60 Hz in its background noise check.
Limits
- It is a plain sine wave. It plays a tone, it does not measure your speaker or find the source of a hum.
- The volume is not calibrated. Your device and speaker decide how loud it is.
- Browsers stop web audio when the screen locks or the tab goes to the background.
- For bass sweeps and rattles see the speaker test.
FAQ
Is 60 Hz the same as 50 Hz?
No. 60 / 50 = 1.2, which is 3.16 semitones, close to a minor third. They are two different pitches. 60 Hz is the mains frequency in the US, Canada, Mexico and parts of Asia. 50 Hz is mains in Europe, most of Africa, Australia and much of Asia. Use the one your wall socket runs at.
Is a 60 Hz hum normal?
A faint hum next to a transformer, a power adapter or a fluorescent light is normal. A hum from your speakers, amp or recordings is not, and it can usually be fixed: it is most often a ground loop or a cable laid next to a power cable. See the hum pitch section below for what each pitch means.
Why can't I hear anything on my phone?
Phone and laptop speakers give almost nothing under ~150 Hz, and many earbuds are not much better. The page is playing the tone, the hardware cannot reproduce it. Try over-ear headphones or a speaker with a woofer.
Is the real hum a pure 60 Hz tone?
Rarely. Real mains hum has a strong second harmonic (120 Hz) and often a third (180 Hz), so it sounds buzzier than this sine wave. For a buzzier sound, open the Tone Generator and pick the sawtooth wave.
Can this tell me where my hum comes from?
It can help you recognise it. If the pitch of your hum matches 50 or 60 Hz, or 100 or 120 Hz, it is probably electrical. It cannot hear your hum, and it does not measure anything.
Can a 60 Hz tone damage my speakers?
At low volume, no. Small speakers can distort or be damaged by loud low tones, so start quiet and turn up slowly. The page starts at 10 % and never plays on its own.
Does it need an internet connection?
Only to load the page. The sound is made in your browser and nothing is uploaded.
More from FLXCode
Tone GeneratorNew
Play any frequency from 1 Hz to 22 kHz. Sine, square, triangle or sawtooth.
Speaker TestNew
Phase, sweep and range. A quick check for speakers and headphones.
Mic TestNew
Check your microphone: level, clipping, a quick recording, and what your browser does to the sound.
Noise GeneratorNew
White, pink, brown and green noise with a sleep timer and fade-out. Plays with the screen off.